Sealing Clamps and Kits

The appropriate clamp depends on the leaking component, equipment design, operating conditions, and the sealing method required. The TDS product is specifically designed for common drain plug sizes and applications including transformer radiator banks, transformer tap changer compartments, oil-filled circuit breaker drain valves, and electric substation apparatus. Confirm compatibility before installation.

An effective repair begins by identifying the leak source and selecting a sealing method compatible with the equipment and operating conditions. For the listed substation applications, TDS uses a fitted aluminum enclosure secured with set screws and crunch teeth, then fills the void with a non-adhering rubber-based sealant. This approach is removable without permanent modification.

These sealing clamps and kits are used for transformer radiator bank drain plug leaks, transformer tap changer compartment drain plug leaks, oil-filled circuit breaker drain valve leaks, and electric substation apparatus leak sealing. The product is intended for specialized electrical power equipment applications rather than general-purpose plumbing repairs.

The product information states that the enclosure can be installed with equipment energized and online. Actual installation suitability depends on the equipment, leak location, site conditions, and applicable safety procedures. TDS personnel include OSHA-certified technicians and specialize in leak sealing for substation equipment, supporting a technically informed evaluation before repair.

The product information states that the Drain Plug / Leak Seal Enclosures & Clamps solution does not require draining oil from radiator banks or compartments. This can help avoid the disruption associated with traditional drain plug repairs. Confirm the specific equipment and leak conditions with TDS before selecting the installation approach.

Yes. The product information states that the aluminum enclosure is removable without permanent modification. It is held in place by two set screws and crunch teeth, while a non-adhering rubber-based sealant fills the void. Removal and any follow-on work should be evaluated against the equipment design, leak condition, and applicable safety requirements.